Chris Howell

Good point. Date is probably not necessary. On Fri, Feb 5, 2021, 6:08 PM Glyn Hudson wrote: > For simplicity do you think it's important for the LCD to show...

Additionally a limit should be added for distance miles/km. Example... Charge to 300km range.

In theory, a future version of the WiFi board could have the reset pin of the serial port connected to a GPIO. If a bootloader were added to OpenEVSE, firmware...

I think it is a great idea. I think we need to be more generic though. ecoMode can be used for more than solar. I would suggest using Power instead...

Looks like default behavior is to connect to the AP with the lowest channel. Looks like there is a way to scan signal strength also. https://www.reddit.com/r/esp32/comments/nphj1c/how_to_connect_to_wifi_ap_has_stronger_signal/ On Mon, Jul 4,...

Try clearing browser cache. On Sun, Nov 7, 2021, 6:34 AM andriuskr ***@***.***> wrote: > Update to newest dev version. Vehicle tab is now gone. > [image: 552299EB-E5E7-41B0-9C1F-39AC12E3190D] > >...

I am not sure about this one. Presenting an IP address all the time seems like a security risk.

8.2.3 is the problem. It was compiled by a developer with Boot lock enabled which locks the station until WiFi boots up fully and unlocks. This is a big problem...

8.2.3 is the problem. It was compiled by a developer with Boot lock enabled which locks the station until WiFi boots up fully and unlocks. This is a big problem...

OpenEVSE has been capable of power-sharing for a very long time, it just takes a fair amount of technical knowledge to pull off. Many of the big guys are offering...