chris-1243

It should be supported in the next official release or in the latest-dev as soon as the PR below will be corrected and merged https://github.com/Koenkk/zigbee-herdsman-converters/pull/9275

You should check #23814. Try the latest-dev. Your problem should be fixed. There was unfortunately a bug in the `deconz` driver only.

Could you try to factory reset one device not working and try to pair it. Carefully read this https://www.zigbee2mqtt.io/advanced/zigbee/01_zigbee_network.html#green-power-devices Pair your device **without** using the `permit join all`. Choose a...

> If i remove the battery from the switch. Hold Top left button to join my zigbee channel 15 network, and then confirm as per the documentation - it pairs...

From version 1.36 to 1.41, the dev might have done some changes. `ember` driver had several changes and a huge improvement to pair ZGP devices through specific routers for example....

As there is no log, it is hard to provide help. I would first check this https://github.com/Koenkk/zigbee2mqtt/discussions/24198 as you have to downgrade to 1.42.0 to have a working version. You...

It is due to those two PRs https://github.com/Koenkk/zigbee-herdsman-converters/pull/9177 https://github.com/Koenkk/zigbee-herdsman-converters/pull/9180 There was a syntax error which had to be corrected. Open the expose tab of your SNZB-02D, wake up your device...

@chpego > thanks @chris-1243 for finding the PR Well, I did the correction as I added the SNZB-02LD and I have been advised by **Koenkk** to modify this part of...

@sdotter The issue have been adressed previously in this thread as well as how to solve it. I kindly invite you to read the post above.

@lukasgierth > MAC channel access failure' (225))' Your wireless spectrum might be too occupied https://www.zigbee2mqtt.io/guide/faq/#common-error-codes Check wifi and zigbee channel https://www.zigbee2mqtt.io/advanced/zigbee/02_improve_network_range_and_stability.html