[hardware::pdu::eaton::snmp::plugin] not working on ePDU G3 Switched

[rk4an]

Hi,

We have EATON ePDU G3 Switched 04.02.0001 but the plugin [hardware::pdu::eaton::snmp::plugin] don't give correct information:

OK: PDU '**********' : temperature '1' status 'disconnected', temperature -273.1 C - humidity '1' status 'disconnected', humidity 0.00 % | '**********~1#sensor.temperature.celsius'=-273.1C;;;; '**********~1#sensor.humidity.percentage'=0.00%;;;0;100
checking pdu '**********'
    temperature '1' status 'disconnected', temperature -273.1 C
    humidity '1' status 'disconnected', humidity 0.00 %

The MIB: http://powerquality.eaton.fr/support/software-drivers/downloads/epdu-firmware.asp?cx=80

I can send a full snmpwalk by email.

Thanks for your help,

[garnier-quentin]

I need also the full snmpwalk of your equipment ?

[garnier-quentin]

I check the temperature as example. I use the table: temperatureTable (.1.3.6.1.4.1.534.6.6.7.7.1) with:

• temperatureProbeStatus (.1.3.6.1.4.1.534.6.6.7.7.1.1.3): 0 = disconnected, 1 = connected

temperatureName.1 = ""
temperatureProbeStatus.1 = INTEGER: 0
temperatureValue.1 = INTEGER: -2731

If you find other good OIDs, let's go!

[garnier-quentin]

You comment it if you have some other OIDs to monitor for your equipment.

[MartinMDS]

Hello, I just find the oid for temp and humidity for this hardware eaton pdu g3

EATON_TEMP_OID=".1.3.6.1.4.1.534.6.8.1.2" EATON_HUMI_OID=".1.3.6.1.4.1.534.6.8.1.3"

Thanks a lot for your help