Cal Heldenbrand

@thiagopradi, yes, I'm using this in production right now as well, and it's a key requirement for how our environments are set up. We have different database server names for...

Hi @thiagopradi! I think this PR should be good to go. I'm actually using it right now in production. The only caveat, is that it requires some changes to the...

https://github.com/ibmdb/ruby-ibmdb/pull/88 Trying this from another angle too, hopefully IBM will accept my patch over there.

I still couldn't get a /ui/ prefix to work behind my haproxy load balancer, even using @bpholt's image. Every endpoint call would return the index file for some reason. I...

It is still a problem, although it's fairly rare and just very difficult to trace down. My suspicion is that it's not specifically your gem, but perhaps an interaction between...

Okay thanks. Is there a specific commit I can roll back to in order to play around with my tests until then?

Also, follow up question, if I manually enter in the endpoints for my OP (issuer, authorization_endpoint, token_endpoint, etc) and run the tests, everything returns OK, but I don't see any...

Yes, I think it's working! I managed to make it through a few tests before a failure. One follow up question, is there a way to provide cookies in the...

@tititopher68-dev, it's currently the stock heater and thermistor, but I just received [this 50W heater and thermistor pack](https://www.amazon.com/dp/B08CVGK8XK), which I'm going to install after my current print is done. However,...

Yes, it's an ender 3 v2, 4.2.2 mainboard. Also I did install the 50W heater, and the temp does increase a little faster, but I still can't comfortably push it...