c0pperdragon

Well, there are some spare pins on the FPGA, but the firmware does not create hsync and vsync internally. Also I have used up the internal FPGA resource to about...

Flashing the firmware has its quirks. There is an issue thread for this specific topic: https://github.com/c0pperdragon/C64-Video-Enhancement/issues/80

Are you sure the JTAG plug is in the correct orientation?  And you need to power the device, it will not be powered from the programmer. Reinhard ----- Ursprüngliche Nachricht...

If I inderstand this correctly, you are just using the original analog output of the VIC-II here (with a simple analog-only amplifier board?). When you really have to use the...

Currently there is no way go get any of these devices. The main component is an FPGA and these are not available anywhere in general, Even worse, the MAX 10...

Anyway, the previous main source of pre-built kits was https://videogameperfection.com/, but they ran out of stock and can not have any more built due to the mentioned chip shortage.

As there are basically no FPGAs available at all (without paying $500 on the spot market of a single part) there is not much we can do. The analog only...

I have actually never bothered to see into the details of this specific board. I only know that there you do not need the RF modulator at all to still...

Yes, this will most likely require individual fine tuning, at least for the Atari 8-bit machines what need the highest data rate of all the supported computers. The C64 and...

@marqs85 If this helps, I could extend the firmware on my signal generator to support all lumacode patterns and just send it to you. So you would not have to...