Brandon Heller

I didn't realize that a commit request would auto-update to include following pushes to the pull-request-specified branch. Regardless, I've printed a part to test the later two commits in the...

It sounds like we're thinking in the same direction. Do you notice a lot of friction from the corners of the wrench grabbing the detents? I'm tempted to add a...

I could also print the part with the flat side that faces the microswitch down to eliminate the effect. I'll hit it with a drill first, though. On Wed, Jul...

I made some changes that definitely help with this, both adding a mini nut trap, and removing the small triangular piece at the edge that fits in the openbeam slot...

Forgot about this one - unfortunately, the little indents didn't seem to help much. With a little practice, using pliers to hold the nuts is not too bad. Tempted to...

Nice, Murphy! Hopefully people will find this useful. It's been so long that I don't even recall the last version of Mininet this was tested with.

Probably; it's been two years since this bug was opened. I haven't looked at the code in awhile but I assume these are still needed to build mnexec.

I also ran into this issue; like andrea-corbellini suggests, I wouldn't be running this if I didn't have big tests. In my case the default of 10 seconds failed, but...

Then maybe connected is the wrong word. Again, NO SWITCHES EXIST in this network. I haven't created them. How about: ``` Switches configured to connect: ... ```

Exactly. Fresh from a reboot: ``` mininet@mininet:~$ ps -A | grep mn mininet@mininet:~$ sudo /etc/init.d/flowvisor restart Sleeping a bit to let FlowVisor shutdown Starting flowvisor with the configuration stored in...