esphome-tuya_pir
esphome-tuya_pir copied to clipboard
brandond
Additional device support
I have it running on a slightly different device, a LSC Smart Door Sensor, but the protocol appears to be the same. However, the reed switch state change is inverted and the event_type is 0x0101. I could submit a PR if you are interested in supporting the extra device.
I knew a few people are interested in the LSC Door Sensors because you can get them in the Dutch budget store Action for less than €10. You have done 99.9% of the work to support these devices too :)
@beardypig : Hi, i flashed the same sensor. I am missing the door open and close mqtt messages. might that be because of the different event type you mention? If so, which line do i change in the sb1_uart.h file? enum SB1EventType : SB1_EVENT_TYPE_DOOR = 0x0104, SB1_EVENT_TYPE_MOTION = 0x6501, SB1_EVENT_TYPE_DOOR_RESET = 0x6504, SB1_EVENT_TYPE_MOTION_RESET = 0x6604
@nicovankampen my IDE messed up all the formatting on the file so I need to clean it up before I can PR the changes, but this gist has the complete file: https://gist.github.com/beardypig/38f9f2d6533ffd274b3b2aad0aa523a8
In the end it's only a couple of small changes.
@beardypig : thanks ! Got i all working now. At first it didn't work but then i found that ESPhome makes copies of SB1_uart in 3 different folders! (very confusing). Replaced all 3 off them. Only thing left now is finding out how to make the binary_sensor always available showing one of two states always.
The example door esphome config works pretty well. The important bit being that you use MQTT with empty birth, will and shutdown messages.