Bram Gerritsen

Ah I read your question again and I see it's not about a group powercalc sensor. There were similar issues with the group sensors and I made a lot of...

Powercalc uses same underlying code for the utility_meter. It's exactly the same logic as the HA helpers use. So when your energy meter glitches making the utility meter misbehave your...

Yes this is by design, when the same device of the power sensor already has an energy sensor powercalc will use that one. You could do the following. 1. Create...

Yes that should also work.

> Thank you so much and thank you for this amazing piece of code. It is the best integration I've found so far!! Thanks a lot for your compliments. Good...

I did not add it on purpose because I want to keep the GUI simple and not too cluttered with options. Only added the imo most used options to the...

Implemented with #1110 After setting the basic configuration options a separate step is shown where the advanced options can be set. Currently I have only added the `calculation_enabled_condition`, but we...

You may test this by installing the master branch.

> Works perfectrly! Now I can split yeelight-nightling and main mode for my ceiling lamp, when I calculate power from brightness. Thank you! Could you elaborate more on this? Can...

Thanks for the extra information. I am closing this issue.