borine

> but I can't seem to get it working at the moment. As noted in the wiki, the Pulseaudio module-loopback does not work with the bluealsa plugin as a module-alsa-source....

I've updated the wiki page with some notes on using pulse's module-loopback with BlueALSA sources, and also mentioned using bluealsa-aplay as an alternative. The bash script has been updated to...

Thanks, that is all very helpful. Given that recompilation of pipewire is required, I think that this all too much to be added on to the existing pulseaudio wiki page....

Hmm, I wonder if this could be related to the introduction of LC3 codec and "super wideband" (SWB) mSBC support in Android 14? Other than that, I can't see any...

> Will this cause the call quality to decrease? No, these log messages are for information only. The +BSIR RESP command is merely an indication from the phone to the...

You can't choose the MTU from user space, it is always set by driver for the HCI Bus (in your case USB,using the `btusb` driver). The MTU values for read...

This issue has been idle for a very long time now. It's a shame that it does not seem to have caught the attention of maintainers of distributions that use...

When 0 < silence_threshold < buffer_size, then the driver ensures that there is always a number of silence samples *ahead of* the appl_ptr in the buffer, so that if the...

> the driver will write silence_size frames of silence after the appl_ptr. Actually it writes a *maximum* of silence_size frames. It may write less than that it reaches the hw_ptr...

> The documentation of silence threshold/silence size only talks about the underrun situation Yes, as I said, that is confusing because they are useful in other situations. When used in...