bmentink

Ramping up the clock rate

7

Not an issue as such, but due to the lack of a forum will post here. I would like to run the clock much higher to see what the limit...

Howto pass options to nextpnr or Yosys

1

I need some custom options to nextpnr like: `--ignore-loops --pcf-allow-unconstrained` etc .. How do I do this, so that I can still build from the IDE .. Also, how do...

Hi, I am trying to build this project with Yosys/NextPNR/ecppack etc open source tool set. I collected all the *.v files in "common" and the two *.v files in the...

pubsub not there?

1

Can't seem to use pubsub any more, compile fails on "import pubsub" line, this used to work fine compiling with toit directly, rather than via jaguar ..

Hi, Impressed with the code .. would like to contribute if possible, but not sure if this project has stalled or has been shelved as see no activity for a...

When is support for Arduino 2.x.x likely to happen .. thanks

14

Great tool, looking forward to Arduino 2 support.

Please provide an arm64 build ..

1

Trying to run on ARM64 Linux on a MacBook Air M1

Won't flash using IDE 2.2.1

77

Hi, I am trying to program LGTBF328P - MiniEVB nano board. I get the following error: ``` avrude error: protocol expects OK byte 0x10 but got 0xfc avrdude error: unable...

Status?

2

@folny Hi, I am wanting to try this, I have compiled the code and loaded up an ESP32-VROOM dev board to test. I have also loaded the Android app on...

Colorlight i5 Pin mapping.

5

Hi Tom, Could not find a way to contact you on the Colorlight i5 project page , so doing so here. I see you did some FPGA mapping to the...