frigate
frigate copied to clipboard
[Support]: Recommended USB Hub back powers Host USB Port, preventing Raspberry Pi boot
Describe the problem you are having
I bought (the recommended USB Hub)[https://github.com/blakeblackshear/frigate/blob/dev/docs/docs/frigate/installation.md?plain=1#L93] for use with the Coral USB. I've noticed a number of times that my raspberry pi wouldn't boot properly, but eventually tracked it down to the USB hub, With the powered USB hub plugged in, it would consistently not boot, but with it not plugged in, it would boot consistently.
I found today in the reviews that there are a number of other people with the same issue reported in the low reviews, so we should probably put a disclaimer. However, given it's in the Raspberry Pi section, I'm not sure how to address this.
Here's a link to images showing the back powering to the RPi https://imgur.com/a/qhRe4Ay
Version
N/A
Frigate config file
N/A
Relevant log output
N/A
FFprobe output from your camera
N/A
Frigate stats
No response
Operating system
Debian
Install method
Docker CLI
Coral version
USB
Network connection
Wired
Camera make and model
N/A
Any other information that may be helpful
No response
I also found the HB-UMP3 on this list of Raspberry Pi USB hubs, specifically calling it out as having a Back Power issue
Depending on what you are running off the Pi you may find it has enough power already (especially the Pi 4).
With a low power SSD I am running that, the USB coral and a zigbee antenna with no issues at all. This is actually running off a Pixel C tablet charger which is a good quality one.
Some SSDs consume a lot more power than others
I tried this UGREEN hub with my raspberry pi, and confirmed that there was no back power applied to the USB port. The Raspberry pi had now issue booting with it.
This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs. Thank you for your contributions.