SKR-2
SKR-2 copied to clipboard
bigtreetech
I've developed a new firmware called Remora, which I've been using on the SKR v1.3 and v1.4. I'm working on a version for the SKR2 but have corrupted the bootloader...
Hello My friends. I have some error when I build marlin witch enable PRINTCOUNTER. Bellow is my error  How I can resolved it?
Hello! My 3D printer configuration: SKR-V2 (BigTreeTech) + TMC2209 (BigTreeTech) working on UART. In Marlin config file TMC2209 drivers set up. I encountered a problem sometime ago. After the 3D...
Purchased SKR2 and TFT screen. Assembling to an Ender 5 Plus. Using 2209 drivers. Compiling Marlin from the bugfix version present on here. X and Z are moving the wrong...
i have bought two skr 2 boards both not working because sd card port not working have also tried btt marlin listed here and vanilla marlin code compiles fine but...
#### Issue: When Configuring of Dual Z endstop in SKR2 board the `Z2_min` fails to get mapped to `XMAX `or `YMAX` pins. #### Steps to reproduce: * Download the latest...
Problem: SKR-2 revB does not power on correctly and does not connect to USB. Expected behaviors: 1) SKR-2 revB and BTT TFT35-E3 v3.0 power on when connected to USB without...
During printing, voltage may be lost on any motor. Only reboot helps. Power supply 12v. DRV8825 driver. What is "Vin 24.0v sensor"? 
Hi folks, I need some help. I can not understand why the move axis X, Y or Z menu entries are missing. I only got the extruder entry.  My...
I'm wondering if it's possible to detect the loss of 12/24v power within Marlin when the board is powered over USB? I power my board over USB, eventually this will...
