SKR-2

SKR-2 copied to clipboard

Endstops always triggered

18

Hello all, for a few days i try to fix my endstop problem. I have a CR10s and upgraded from the original mainboard to the skr2. I never had any...

phenix1990

SKR 2 Q2 mosfet blow up

1

Hey. so i just got my SKR 2. rev B (with 429 chip) and TMC2209 i hooked it up with components from my Creality CR-10S (PSU, steppers, end stops.) i...

Eth0dk

BTT SKR 2.0 Rev.B + TMC2209 on Anet A8Plus Sensorless homing issue Marlin Bugfix 2.0

2

I have setup my SKR 2.0 Rev.B on Anet A8 Plus and everything seems to work fine. Setup includes 3D-touch and double Z stepper drivers. But when I try to...

SergedeParis

UPS power off and resume just doesnt work when you instert an usb in the TFT35 screen. Its working when plugging an USB in the board..... WHy is that??

Justdigit

SKR 2 Not working with BTT TMC2226

2

Hello everyone! I have a big issue with SKR 2 and BTT TMC2226. Im setting up Marlin for 2209 with UART, putting jumper in places like in manual, but having...

mmoustache

Use WIFI Plug For Additional IO

2

I would like to use the custom user buttons functionality in marlin but I have no available IO left on the board. I am not using the wifi functionality at...

3D-Lasers-Lab

But the card doesn't work with Udisc and sdcard at the same time. Do you already have a solution for this with this tft 35?

NunoFilipePereira

3D Touch stopped during "auto home"

6

Hi, I added a 3D Touch on my **SKR 2 motherboard** on my **CR10** and when I do `auto home`, the 3D Touch probes in a vaccum, the Z axis...

valentin-harrang

SKR 2 w/ TMC2209 - TMC CONNECTION ERROR on 3 out of 5 Drivers

10

Hi, I've run into a bit of a problem where my SKR 2 board is set for VCC power and is throwing low errors for me Y, Z, Z2(which isn't...

cjmalchow

TMC connection error - TMC 2130

3

I was wondering if someone could help me figure this one out. I'm new to setting up a board with new drivers so it's likely i've made a mistake somewhere....

umangmd