MicroProbe
MicroProbe copied to clipboard
bigtreetech
Hello Biqu team, I have a B1, just received the microprobe V2 and it is very difficult for me (and a looot of people) in order to edit the firmware...
This isn't documented very well reguarding Marlin configurations. I acquired the Hurikan Configuration.h file to use as reference reguarding settings related to the probe and my printer wont even run...
I'm attempting to follow the instructions of the MicroProbe V2 manual, which is on this GitHub, and I've been running into error after error. >note: this is the location of...
I have followed the directions in the pdf and the build fails as the pins are wrong. I left the pins commented out and it builds, but none of the...
Manta M8P with HermitCrap V1 was working fine with microprobe V1.2. After the pin get damaged and replaced with microprobe V2 it keeps given the some error, "Endstop z still...
Hello Im familiar with compiling firmware but im not a pro. I have successfully gotten Microprobe v1 to work and it worked great for months but I broke the pin....
Marlin Firmware, Everything was set properly; it did the homing successfully, did the bed levelling successfully. Out of a sudden, the PIN started to get stuck inside when homing. When...
When I turn the printer on, the probe will deploy and retract properly, but after the probe deploys for homing, it doesn't retract, it just stays out. I have to...
Give marlin open source with v2 probe setup!!! Since in the compiled file from the offsite, the saving of settings is deliberately disabled. And every time you restart the printer,...
Starting this thread as I work through getting an up-to-date bugfix Marlin implementation running on my not-very-Ender 3v2. After getting the probe successfully operational on my Creality 4.2.2 board (...
