Manta-M8P
Manta-M8P copied to clipboard
bigtreetech
Hello, I have "Global scaler" communication problems with various brands of TMC5160 drivers. In the examples, there are some pins in the table, there are others. I have tried several...
Why is the 3v3 LDO AS1117 fused to the 5VIN net? Should it not be that the LDO is fused to the 5V net? Right now there is the problem:...
Hi, does anyone know what the ic in the yellow block is called, I had my blower fan on fan4 die and it took that component with it, I'm hoping...
**Chapter 2.2** of the latest User Manual is using the old v1.0 Pin-Out Diagram. This threw me off and caused me hours of troubleshooting. The diagrams within the /Hardware/ folder...
I have connected working thermistors on the Manta M8P on THB and TH0 and they are reading 110.9 and 107.4 degrees even on off states (no heat applied). These work...
This chip is shown in the user manual:  But the adxl345 I bought is like this (same with klipper office manual):  The pin name is different between these...
Hi, I'm running a modified X5SA with an LGX large on a Manta M8P and for some reason my extruder retraction goes the same direction as extrude. I've tried different...
have a new Manta M8p where the CB1 green light turns on for a sec upon turning on and then turns off (MCU being fine), but if i wait for...
"BIGTREETECH MANTA M8P V1.1 PinOut.png" lists two different Pin-Outs for FAN4. V1.0 has three 4-pin fan headers while v1.1 only has two. FAN4 in v1.1 is now a two pin...
Some of the settings in the Klipper config for Voron2 are incorrect. Here are the lines affected with corrections ## Z3 Stepper - Front Right on Motor6 [stepper_z3] step_pin: PA10...
