SB2209 USB need modded STLs

[Steiner-SE]

As is the SB 2209 board is not even remotely compatible with the Galileo 2 extruder (and probably any related extruder) as the back USB port cuts into the main body. I found a third party modded main body that partly solves the issue, but the board end up installed angles and under some stress as it catches on the top part and end up installed at an angle (potentially misaligning the connectors for the sub board). Likely a new main body and door is needed, and with the higher XT30 connector a new umbilical solution.