BTT-E3-RRF
BTT-E3-RRF copied to clipboard
bigtreetech
So i have a adafruit neopixel ring around my hotend wich worked well untill i accidently shorted something while cleaning my hotend with a wirebrush, the neopixels went out, eventough...
I'm trying to trouble shoot the fans on my BTT-E3-RRF V1.1 not working and I suspect that the pin mapping is not correct in the firmware. I need the schematic...
Can BTT release basic component schematics for this board, as I have several with damaged PWM fan headers, and I would like to repair them.
When printing from sd card printer (Ender 3) reboots after few layers, but when using pronterface that issue is not present. Firmware is Marlin bugfix 2.0.7.2.x., board bigtreetech e3 rrf...
Hello, I have a problem with the FAN0 and I would like to fix it, but there is no schematics of the board BTT-E3-RRF available. I measured the input of...
Is it possible to use a generic led strip on the neopixel pins?
I've been fighting this issue for months now on my diy IDEX build. I have the BTT E3 RRF V1.1 along with the IDEX expansion board. It oscillates +/- 15...
When building the mainboard into a new case the original antenna wire got snapped of the sticker part. I tryed to resolder it but didnt work. Now im lost on...
How to I configure reprap to use a PT100 thermistor with the IDEX board how to I set the thermistor in the config.g file? Searched everywhere and havent found an...
Hi, i have a problem with my e3 rrf. i uploaded a marlin firmware, all is done, and i search now at update the firmware,but the motherboard dont accept it...
