BIGTREETECH-OCTOPUS-V1.0 icon indicating copy to clipboard operation
BIGTREETECH-OCTOPUS-V1.0 copied to clipboard

Published 20 hours ago • verified publisher icon bigtreetech

Uart / PINOUT

Open JamesD3d opened this issue 3 years ago • 3 comments

The uart pin in klipper refers to Expansion pins in the pinout. Which is correct?

JamesD3d avatar May 31 '21 21:05 JamesD3d

For stepper drivers use the cs pin from the driver section of the pin diagram, I set mine up over the weekend and needed to get them working. My bad if it wasnt driver uarts you where after, if it was this should help

Jasonpenman avatar Jun 01 '21 20:06 Jasonpenman

Thank you . It was very confusing because the sample klipper config pointed to expansion pins as uart pins for the 2208s.

Thank you.

On Tuesday, June 1, 2021, Jasonpenman @.***> wrote:

For stepper drivers use the cs pin from the driver section of the pin diagram, I set mine up over the weekend and needed to get them working. My bad if it wasnt driver uarts you where after, if it was this should help

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0/issues/18#issuecomment-852420085, or unsubscribe https://github.com/notifications/unsubscribe-auth/AFFMALWAUEB6UPEDIG6ONGTTQU6LZANCNFSM453PPTJA .

JamesD3d avatar Jun 02 '21 11:06 JamesD3d

Glad to help, i was super careful setting klipper up for it. Seems a really good board so far

Jasonpenman avatar Jun 02 '21 11:06 Jasonpenman