"cannot create directx/opengl interop" error-loop

[toastbrotch]

i created a patch (i tried to spout out an example but got only black feed), saved it and on re-open i end up in a "cannot create directX/OpenGL interop" error-cycle. livecode-spout-001.zip

windows10, spout2.005, intelHD grafixcard

actually this seems a spout problem. i had to open the "Spout DXmode" app and set its mode to memoryshare or DirectX9 . at least at this point i was able to use the demosender/receivers. and fugio then starts without error-loop. i can also select the fugio stream in the receiver...

so this might be not a problem of fugio, but spout...

[bigfug]

It does sound like an internal Spout issue as Fugio doesn't report that error. I'm going to close the issue but let's keep an eye on it.

[toastbrotch]

jep it is a spout error message, maybe fugio should not end in an infinite-error-loop where one can only get out by killing the program... but maybe this is not an issue at all, as users should have tested their spout setup with the included spoutsender/receivers first.

[bigfug]

OK, I'll have a look at that next week