beanian

That could be it. I wasn't aware there was a difference in bluetongue protocols depending on firmware. Have you a source of or more information on this? I have only...

Thanks for your help, I tried that and i'm getting this message now ``` [+] Connecting to device C1:43:18:00:00:01 [+] Writing 0x81fb8d008041e17a696a1b80e0c3f446afe3ff to BTLE handle 0x21 [-] A communication error...

@nkaminski I have attached my snoop log. I followed the following procedure 1. Enabled snoop log 2. connected to MOVE device 3. Issued a blind up command 4. issued a...

@nkaminski the network key is 8888. Yeah I was looking at it in wireshark to see if I could make sense of it but I'm not familiar enough with bluetooth...

@nkaminski Did you get a chance to look at this?

@pieterdv do you have any sample code you can share on how to use puppeteer to login to AAD and subsequently set these cookies in cypress?

@pieterdv Thanks you! How do you handle the quick redirect to AAD and back again to validate the token when doing a cy.visit with the token set? There seems to...

@abu-wizata Are you setting the cookies in cypress based on the cookies that were set during the login process in puppeteer? We do this in puppeteer at the end of...

Thanks, tried following the steps to capture the traffic, however upon launching the modified Bluelink app I get a message saying "This application has been forged" and it quits. Any...

Just tested this on my Hyundai Ioniq 5 in Ireland and it does not work. When I call the service it unlocks the car and the charging port door remains...