Grbl_ESP32_MPCNC_Controller icon indicating copy to clipboard operation
Grbl_ESP32_MPCNC_Controller copied to clipboard

Published 20 hours ago • verified publisher icon bdring

Dual endstops per axis?

Open tortfeaser opened this issue 5 years ago • 1 comments

Hi, thanks for this design.

I've just pushed the button for an order from JLCPCB then noticed J3 doesn't allow for separate limit switches for separate motors on X and Y axes? Does Grbl allow for this? I was hoping to run this board on a V1 Engineering Lowrider where separate minimum limit switches for each of the two X axis rails to allow for autosquaring (and same on Z min).

Am I talking nonsense? Or does Grbl (unlike Marlin) not allow for two limit switches for each X motor?

tortfeaser avatar Feb 03 '20 22:02 tortfeaser

Sorry. Just realised this is a dumb question. Two switches are connected and the firmware moves one motor at a time and waits for one of the switches to trigger.

tortfeaser avatar Feb 04 '20 02:02 tortfeaser