axg20202
axg20202
Thanks Terje. Understood. If there is a tweak I can make at compile time to make the enable go high when I start the VFD, that would be ideal.
Possibly, but I'd much prefer a firmware solution that uses no additional wiring and lets me use the vac controls on the BOB instead, which also has a header for...
I'm currently using the vfd to trigger the spindle water cooling pump. Could get messy adding another thing to trigger. Could be doable I guess, but a line or two...
Thanks for adding this feature. Alas, I don't think it solves my problem. I'm using the dust TTL signal outputs of the BOB to trigger the relay to switch on...
Hi Phil. Yes, I'm compiling my own. My head is spinning tbh :-) I'm not understanding how the pin assignments for aux and enable relate to their physical outs, and...
$pins [PIN:14,Emergency stop] [PIN:16,Feed hold] [PIN:17,Cycle start] [PIN:15,Probe] [PIN:20,X limit min] [PIN:21,Y limit min] [PIN:23,Y limit min 2] [PIN:22,Z limit min] [PIN:36,Aux input 0,P0] [PIN:30,Aux input 1,P1] [PIN:34,Aux input 2,P2]...
Pins above. I then changed fan 0 out to AUX 3, hit save, and did a hard reset. It sent the board back to 'unable to communicate'
Calling it a day today. Will revisit this tomorrow. Thanks for your help guys.
Brilliant! Is this relatively easy to accomplish when self-compiling too?
Great. Thanks very much for your help with this.