Arduino_LSM6DS3
Arduino_LSM6DS3 copied to clipboard
arduino-libraries
LSM6DS3 Library for Arduino
Suggested by @tigoe: > * six faces (you did this for the Curie as I recall) > * accelerometer tap > * gyroscope as a knob, rotating around the Z...
Requesting an enhancement to include access to the on-chip temperature sensor available on the LSM6DS3 device which can be accessed from the OUT_TEMP_L (0x20) and OUT_TEMP_H (0x21) registers.
Feedback from @tigoe. > Would be good to add functions to set the range and rate, like with the old CurieIMU. @cmaglie was there any reason why this wasn't included...
Suggested by @tigoe: > I'd do the calibration as a library function if we can. If people can call it in setup and know that the offset variables are available,...
Running [SimpleTempSensor](https://github.com/arduino-libraries/Arduino_LSM6DS3/tree/master/examples/SimpleTempSensor) results in readTemperature() returning nonsensical values that change based on the temperature. ``` Temperature sensor sample rate = 52.00 Hz Temperature reading in degrees C T 123.12 126.44...
I have compiled and uploaded the three following sketches, on two different laptops: - [SimpleAccelerometer.ino](https://github.com/arduino-libraries/Arduino_LSM6DS3/blob/37e37457e69467ca2a51aaf6d2e0b4de149053e8/examples/SimpleAccelerometer/SimpleAccelerometer.ino) - [SimpleGyroscope.ino](https://github.com/arduino-libraries/Arduino_LSM6DS3/blob/363d58d24714cdcce53cfc783c684ed6c601c074/examples/SimpleGyroscope/SimpleGyroscope.ino) - [SimpleTempSensor.ino](https://github.com/arduino-libraries/Arduino_LSM6DS3/blob/7aa91655b21b07f5b074a80a83bf17236dc0d64e/examples/SimpleTempSensor/SimpleTempSensor.ino) In all cases, the examples are compiled and uploaded without error....
Hello! Ran into some strange behavior that probably has a very obvious explanation, but figured I'd post here in case someone else was looking for a solution. Have a very...
I noticed that on modern Arduino Uno Wifi R2 the end() is not defined, and it does not compile. However, with endTransmission() it does.
Is there a method to set SDA and SCL pins for Wire to use in this library? I have a custom PCB and need to set the SDA and SCL...
