antimix

Hello, I am currently using the M5Stack always connected to the power, so it never turn off. Only the LCD goes off in back light mode. However I have discovered...

Hi, I am not sure if it is a real good idea. Having the possibility to not start a plugin at HA startup, or even stop it, may be useful....

**IT SEEMS THE MK3S+ WORKS WELL WITH FW REVO 3.13.0**, but _you have to do an additional step._ I have upgraded my MK3S to MK3S+ and in this occasion I...

> Same issue here after upgrading to firmware 3.13.0 for mk3s with revo upgrade. Also tried a full factory reset without any better results. > > The printer is an...

E3D is an established partner of PRUSA and their REVO line is used in other hi-end PRUSA printers, and moreover it was supported on the old MK3S firmware, so PRUSA...

Now I have just purchased the new REVO High Flow nozzle, so having a 60W cartridge it would work better. But unfortunately for now I will have to use the...

I got the same error, but I did not want to risk since a bad handled 60W heater can cause severe risks. So I dismounted the 60W and installed again...

Today I have done an official request to E3D to collaborate with PRUSA in order to develop the 60W support in the PRUSA 3.5 Firmware via Ticket# 126214 Let's hope...

Here is the last response from E3D support: > _Hi there, > > Thanks for getting back to us! > > I have already passed on your request to the...

Hello, I got the official answer from E3D regarding the future develop of the 60W heater on MK3.5 below: _ > Ayoub Khouyi (E3D Online) > > Sep 24, 2024,...