zsgx1hacks icon indicating copy to clipboard operation
zsgx1hacks copied to clipboard

Published 20 hours ago • verified publisher icon ant-thomas

ASECAM CloudCam, Model: Y4C-ZA based on GK702, Want to know pins or pads to solder ethernet plug

Open VU2ATX opened this issue 5 years ago • 12 comments

Hi, ASECAM CloudCam, Model: Y4C-ZA based on GK702, Want to know pins or pads to solder ethernet plug.

This cam is working perfectly fine on wifi. I have taken some snaps of the CloudCam for reference. I want to interface this camera with Raspberry Pi on ethernet. Also, I could not find anywhere the datasheet of GK7102. Pls support. IMG_20191010_164041 IMG_20191010_174515 IMG_20191010_164450 IMG_20191010_171759

VU2ATX avatar Oct 10 '19 16:10 VU2ATX

This is the same as the Digoo M1. The serial port is as shown in the attached photograph. I actually attached the ground cable to the other three pin connector because I needed the space. You can see this if you look closely. The GND connection is on the lower lefthand side of the photo but this was just for convenience. Digoo M1 Serial Port

bitfarmer avatar Oct 30 '19 13:10 bitfarmer

@bitfarmer thanks but I need ethernet (LAN) connection pin detail and not serial port.

VU2ATX avatar Nov 13 '19 14:11 VU2ATX

This is the same as the Digoo M1. The serial port is as shown in the attached photograph. I actually attached the ground cable to the other three pin connector because I needed the space. You can see this if you look closely. The GND connection is on the lower lefthand side of the photo but this was just for convenience. Digoo M1 Serial Port

Hello bitfarmer, How did you make this plugin? dupont connector?

dtalens avatar Feb 13 '20 22:02 dtalens

I used three individual prototyping cables with round pins at each end. The Dupont cable pins are square and too big to fit in the holes on the board. I have these cables for so long that I don't know where I got them from but I reckon they are common.

I just did a quick search and I see they are all over the place! For example: https://www.ebay.co.uk/itm/65-Solderless-Flexible-Breadboard-Jumper-Cable-Wires-for-breadboard-prototyping-/262341198322

bitfarmer avatar Feb 14 '20 11:02 bitfarmer

@bitfarmer thanks but I need ethernet (LAN) connection pin detail and not serial port.

VU2ATX: did you ever find out if there is a way to add an ethernet port? I wonder what the empty soldering pads on the top left side (ref the photos above) are for.

Maarten

maartenjd avatar Mar 19 '20 21:03 maartenjd

Hello I have a little too much play with this camera and I have damaged it I'm looking for firmware and method to install it Thanks in advance

arthur5444 avatar Jun 01 '20 09:06 arthur5444

ЗДРАВСТВУЙТЕ. Подскажите пожалуйста. У меня выключилась камера и больше не включается. Что может быть? И где копать?

dragon100000000 avatar Feb 08 '22 18:02 dragon100000000