ADVi3pp
ADVi3pp copied to clipboard
andrivet
ADVi3++, an alternative and better firmware for Wanhao i3 Plus printers and clones. Fork of Marlin Firmware.
### Did you check that your request is not a duplicate? Yes, I have checked and this is a new request. ### Is your request specific to your setup only...
### Description probes to work the BOARD_ADVI3PP_I3_PLUS_51. Works with proximity and other switch-like probes. Configured to be normally on and off when activated. ### Requirements Switch-Like probe connected to port...
### Did you check that your report is not a duplicate? Yes, I have checked and this is a new bug not previously reported. ### Bug Description The new manual...
Hi, I noticed that after flashing 5.4.0 i'm getting the warning that the black and white wires may be transposed. I have checked the wiring and all is correct. This...
### Did you check that your report is not a duplicate? Yes, I have checked and this is a new bug not previously reported. ### Bug Description Homing can be...
### Did you check that your report is not a duplicate? Yes, I have checked and this is a new bug not previously reported. ### Bug Description If the printer...
https://www.youtube.com/watch?v=R2zufbNlJRQ https://www.youtube.com/watch?v=R9OHYq-Ws-w&t=941s https://www.youtube.com/watch?v=hEk3aVARSGc&t=740s
This is a feature request for adding the ability to adjust the flow[1] during a print. This is similar to the existing features of adjusting the feed rate, fan speed,...
------------------------------------------------------------ ### Feature Request I saw that you have added milestone for automated bed leveling, but I was hoping to add a request to also allow access to the manual...
Thank you for submitting your feedback to the ADVi3++ project. Please be sure to review our [code of conduct](code_of_conduct.md) and the checklists below before submitting and use one of the...
