Arnaud Mouiche

Hi. There are plently of possible solutions. U-boot is even able to directly load files from an IDE device of from some filesystems So a solution could also to  used...

On Wed, 2022-11-16 at 06:06 -0800, killemov wrote: > Positive feedback but ... > > And even if you could flash a Bullseye, or larger, kernel or go > >...

Hi. >  it installs via TFTP Can you detail the uboot cmd you use to do such operation ? Arnaud On Wed, 2023-11-15 at 13:50 -0800, graemev wrote: > I...

On Thu, 2023-11-16 at 04:21 -0800, graemev wrote: > I guess I was unclear WRT "it installs via TFTP" > I was referring to the process , whereby: > 1....

On Thu, 2023-11-16 at 08:37 -0800, graemev wrote: > 1st: > Marvell>> sflash info > Flash Base Address : 0xf8000000 > Flash Model : ST M25P128 > Manufacturer ID :...

It is, but you way just tweek the debian install script. It will be  - Follow https://github.com/amouiche/qnap_mtd_resize_for_bullseye/blob/master/Recovery.md  to re-intall the QNAP original firmware using the QNAP TFTP method - re-install...

Hello, the 'NAS config' partition really only hold stuff required (even not sure ?) for the QNAP firmware. The script tries to resize it for clean behavior, but, given you...

Hello. Sorry, didn't get time to look at your question before this week-end. I just updated the documentation to add a section concerning the recovery. https://github.com/amouiche/qnap_mtd_resize_for_bullseye/blob/master/Recovery.md Please, can you see...

On Sat, 2023-12-09 at 07:17 -0800, David Douard wrote: > As I mentioned there, I have successfully installed Debian on my old > TS219P (so I can use it as...

On Fri, 2023-07-21 at 05:52 -0700, bo911 wrote: > Thank you, for your help > My Target is debian 11, so I just do some minimal deian10 > installation, and...