Ali Masood

Just update the ecu definition. And use your tune from the last firmware version. On Mon, 1 Aug 2022, 9:50 pm Alexey Dobrovolsky, ***@***.***> wrote: > Hello! I've uploaded last...

Hey Zoatex, Did you plug the ECU in with the laptop connected? as that too would prime the fuel pump. On Tue, Nov 3, 2020 at 1:08 AM zoatex wrote:...

hmm, I would check the power circuit to make sure you don't have the DME relay permanently engaged. On Tue, Nov 3, 2020 at 9:11 PM zoatex wrote: > Yes...

have you tried doing a composite/tooth log in tuner studio with in the diagnostic and highspeed loggers?

if you arent seeing anything on crank sensor, i would recommend tracking the schematic of the crank signal and seeing where something could have gone wrong, also are you a...

also is your jumper config as follows 1,6,10,11,14,28,29,30, JP31:1-2, JP21:2-3, JP22:1-2, JP4:1-2?

m52's do indeed have hall sensors, if you still have the factory ECU, connect it and see if it starts the engine. and yes do that, I am off to...

Hey Dave, Nice one, let us know how it goes. Ali On Tue, Sep 22, 2020 at 12:06 AM DWILSON357 wrote: > Hey Ali, > > The sensor tested bad,...

Given the shape your tooth log, id say you have your rising edge and falling edge mixed, as you should see 57 teeth, and 1 tooth 4 times in length...

since your tooth log is seeing crank rotation currently, i have no idea why the speeduino isnt picking up the RPM, what firmware are you running, try the 2020-05 firmware,...