aikar
Moving slider to 0 range will change to the 'All' view
When loading/refreshing the timings report page, the 'count' is lower than it should be, and therefore gives a high % of tick.
When moving the slider of the timings time-range all the way to the right, and then move the slider back to where it was originally, it shows different timings that seem more accurate.
I tested this with a completely blank 1.19.2 server without any plugins and the latest version of paper at the time of writing (286). I'm using google chrome as a browser.
The timings report of the blank server https://timings.aikar.co/dev/?id=b69fa8da578641eea89026c7195be442
Initial page load
Move the slider to the right
Restore the slider's original position
Default view mode is lag, which shows ticks which took too long, rather than all ticks; given jvm warmup, etc, losing a few dozen ticks on startup ks expected; you see that in your view where the count is showing all ticks, you're now in all view
Oh, I see what happened! Thank you for pointing that out! I didn't notice that it changed the view mode when moving the slider.
To summarize and be make sure we're on the same page: The default view mode is 'Lag' Then whenever the slider has a range of 0 included ticks, the site decides that 'All' mode should be the new view. (without me changing the view mode directly)
I misidentified what the cause of the count change was. I'm not sure if that is the intended behavior though. If it is, then we can close this issue now.
I don't think that moving the range slider should impact the view mode at all. I think it's quite confusing.