Magnetic_rotary_encoding
Magnetic_rotary_encoding copied to clipboard
Published
20 hours ago •
ahmsville
ahmsville
Interrupt Wiring
sorry for the bother again I'm trying to figure out how to setup the encoder with interrupts and not exactly sure how to wire my hall effect sensors.
I would assume that the signal pins are both connected to the analogue inputs as well as the interrupt inputs. I couldn't use pins 2 and 3 since those are my SDA and SCL pins and being used for a OLED display. My board, arduino pro micro (Leonardo), can use pins 0, 1, 2, 3 and 7 for interrupts. when I tried a test just wiring the sensor outputs to them though there was no life on the counter.
Am i wrong to assume a simple wiring directly to both inputs? I haven't used interrupts before so apologies if this should be obvious.
