Info on pi pico pinout and compiling.

[longboarder241]

I saw the video on the playlist describing how this firmware can be used with the pi pico however setting this up with this device is very minimal.
(https://youtu.be/hcgtolaM_6g) The wiring to the pico is quite descriptive," start at GP2 and connect all the pins thru to GP14 in a row, skipping over the ground pads (dont forget to connect one of the grounds of course)" however I cannot properly figure out which pins interface directly with the floppy disk drive (and in addition 5.25 data connectors if compatible) Perhaps the precompiled firmware for the feather rp2040 will be cross compatible with my pico but I don't know for sure until I have the ability to wire it to my disk drive. If that is not the case it'd be helpful to know how to set that image up.

Regards.