acidtech

Phil Elwell. The 5 seconds is a fact of life , yes. The 9 second delay is not. Or was the 5 seconds to calibrate and get to boot just...

I think I may have figured it out. Pi4 has wider range of dotclocks supported I assume? On the right track I think? I put in a dpi_timing for another...

And yes, that worked. I bumped my dotclock up to 32mhz and then increased my front porch and back porch to compensate. Still fiddling but I would like a list...

HuBowen1031, it appears english is not your first language so I will assume a misunderstanding. 1. I have fixed my problem by setting a higher dotclk. 2. I asked for...

Start a new thread. Don't hijack this one. Nathan Scherdin On Tue, Aug 18, 2020 at 6:17 PM HuBowen1031 wrote: > Oh,I have a big problem,That is my USB drivers...

The problem is Pi3, Not Pi4. Pi4 works at Dotclk/PV frequencies that the Pi3B(+) does not. I physically tested that. For example I used a 24mhz clock on Pi4. No...

No problem. I dont have mine hooked up right now either. In the middle of a move to a bigger office. I'll set up a test asap and get back...