absalom-muc

So far I've the following understanding: ``` bit0: burner for heater (0/1 : off/on) bit1: overrun (so far I've only seen in combination with bit0=1 (0/1 : no overrun/overrun) ???...

In my point of view it makes sense to map '4' to 'warm water'. But I'm not sure if it is really related to pumpstate only because it is !=0...

During the test BMUB51101HwcState was always 2 and BMUB51101ErrorStatus always 0. The other values are visible in the diagram:  As you can see pumpstate is related to SDFlame.

Spontaneously I have no idea why this could happen. Especially since a Tsetpoint of 33°C is an invalid value for the AC (max should be 30°C). Some questions: 1. Does...

I don't know the HA implementation. What is displayed in the row `[12:06:16][D][climate:414]: Target Temperature: 22.00°C`? It is the standard Tsetpoint (listed in the table in this [clause](https://github.com/absalom-muc/MHI-AC-Ctrl/blob/master/SW-Configuration.md#mqtt-status)) or is...

> Hi, > > Is the AC actually targeting a 2 degrees higher temp then was set? Would it be a valid assumption that when the AC is in heat...

> This behavior has nothing to do with the MHI-AC-Ctrl software. An offset of 2°C in heating operation is determined by the AC itself. You can turn this off by...

Thank you for pointing me to TSR1-2450e. Have you found a comparison TSR1-2450 vs. TSR1-2450e? Spontaneously I found only that TSR1-2450e has a slightly lower Voltage Set Accuracy of +/-4%...

Thanks for yor feedback @FloR012 A discussion related to the TSR1-2450E was started [here](https://github.com/absalom-muc/MHI-AC-Ctrl/issues/102). I had also the impression that the 'E'-version it an adequate replacement - good to hear...

implemented in v2.6