Zeioth

You are right. I've been tweaking a couple of hours. This is as far as I've come. I'll continue tomorrow. I've had to delete memdisk and plymouth from mkinitcpio-archiso.conf though....

I'll try it again tomorrow. @philwyettreb could you post the steps you followed to build the ISO, please? That would be really awesome. **EDIT**: I just built it with success...

I think I've found an easier way: 1) Copy this file 2) Run it [iso-builder.txt](https://github.com/Antergos/antergos-iso/files/802582/iso-builder.txt) Thank you guys!

I flashed the drivers with [the instructions you provided](https://github.com/manna-harbour/qmk_firmware/tree/crkbd/keyboards/crkbd/keymaps/manna-harbour#sample-configurations) BTW sudo make clean && sudo make crkbd:manna-harbour:avrdude-split-right MH_MODULE=trackpoint MH_AUTO_BUTTONS=yes MH_RGB=matrix LTO_ENABLE=yes sudo make clean && sudo make crkbd:manna-harbour:avrdude-split-left MH_MODULE=oled MH_OLED_MODE=static...

A couple photos  

Just to be sure I made another driver board, and this time I'm getting this values: driver board RST (0.0V) | GND (0.0V) | VCC (4.25V) | CLK (4.25V) |...

Also, I'm using unpolarized ceramic capacitors, that's probably causing problems too. I'm gonna try with "[3216A 16V 2.2UF 225C](https://es.aliexpress.com/item/1005001785801523.html?spm=a2g0o.cart.0.0.22263c00dIM1mc&mp=1)" instead.

Meanwhile I've made the screen in inkscape so anyone can just print it. [corne-screen.zip](https://github.com/manna-harbour/crkbd/files/6185259/corne-screen.zip)

No idea what could be the cause, but it doesn't happen on my end with sway 1.7 and wofi. Did you try with a different wofi config file?

5 monitors, all of them UHD (3840 x 2160). My config, if relevant: ``` output $screen2 mode [email protected] pos 0 0 scale 1 output $screen3 mode [email protected] pos 3840 0...