Powering Liligo Ttgo t-call

[gpalmia]

I would like to power a Lilygo ttgo t-call controller (esp32 + sim800) with LiPo battery (type 18650). Under the board there is a jst-ph 2mm connector but, if I connect, the LiPo battery to this connector the board is not powered. However, I discovered that if I connect together the battery via jst and the USB port to the PC the board is powered and then if I disconnect the USB socket the board continues to be powered only by the battery. Is this normal behavior? If so, how can you power the board without connecting to a PC, in particular if I use the deep sleep mode, during which the board stops being powered and then, when it wake up, powered again?

[mashrurbd]

Please click on the EN button on the board.

[gpalmia]

OK, if I press the EN button it work fine but if the code send the T-Call in sleep mode it does not awake. Any advise?

[Rob58329]

See https://github.com/Xinyuan-LilyGO/LilyGo-T-Call-SIM800/issues/87