LilyGo-LoRa-Series
LilyGo-LoRa-Series copied to clipboard
Xinyuan-LilyGO
LILYGO LoRa Series examples
I have a T-BEAM AXP2101 V2.1 with SX1262 There are examples for using the AXP2101, but I cannot find a clear list of what each of the AXP2101 channels actually...
LMIC use DIO1 but in this version is not connected. See https://github.com/cyberman54/ESP32-Paxcounter/issues/1005 ¿there is any workarround?
Hi there, I am trying to use the LoRa transmitter, i wanted to try this by running the example code "LoRaSender" but i constantly have this message on the serial...
 Good morning, I have two "T3 V1.6.1" boards (ESP32 433/868/915MHZ 0.96 Inch OLED SD Card WIFI Module[Q134]), and used the ArduinoLoRa Transmitter and Receiver examples. But the signal, even...
On the LilyGo website it shows this image; https://cdn.shopifycdn.net/s/files/1/0617/7190/7253/files/pin-diagram_1024x1024.jpg?v=1656990080 However I have the V1.2 version with a different AXP chip but the diagram is for the V1.1 Are the pins...
I am still puzzled by the failure to see the wifi network created by the T3S3 in my experiments in the field, although it worked at home. See this now-getting-old...
On the T-Beam v1.1 the ESP32 runs off of "+3V3" which is connected to "VDD3V3" which comes from the DCDC3 output of the AXP192. But in the schematic for the...
The sales page for this new board does not let one choose the radio type or band, so either there is an error in the page, or this is not...
I cannot connect to the wifi network of one of my T3S3 boards (out of 3) when it is in SoftAP mode. The same .bin flashed into another board of...
I am experiencing issues with connecting a sensor to the I2C interface on my LilyGO LoRa32 board. I have connected the sensor (SHT20 humidity and temperature DFRobot) to pins 21...
