Error while trying to run default code from nodemcu Esp8266

[dotjavafile]

Hello I am trying to run the default code provided in the tutorial in nodemcu v1 esp-12e.

github.com/WorldFamousElectronics/PulseSensor_Amped_Arduino

It runs in my arduino uno fine but when I try it with the nodemcu I get following error. Please help.

Read more: http://pulsesensor.proboards.com/thread/474/error-trying-default-code-nodemcu#ixzz4Rbo00iGf

`Interrupt:27: error: expected constructor, destructor, or type conversion before '(' token

ISR(TIMER2_COMPA_vect){ // triggered when Timer2 counts to 124

^

C:\Users\Zero\Documents\Arduino\PulseSensorAmped_Arduino_1dot4\Interrupt.ino: In function 'void interruptSetup()':

Interrupt:17: error: 'TCCR2A' was not declared in this scope

TCCR2A = 0x02; // DISABLE PWM ON DIGITAL PINS 3 AND 11, AND GO INTO CTC MODE

^

Interrupt:18: error: 'TCCR2B' was not declared in this scope

TCCR2B = 0x06; // DON'T FORCE COMPARE, 256 PRESCALER

^

Interrupt:19: error: 'OCR2A' was not declared in this scope

OCR2A = 0X7C; // SET THE TOP OF THE COUNT TO 124 FOR 500Hz SAMPLE RATE

^

Interrupt:20: error: 'TIMSK2' was not declared in this scope

TIMSK2 = 0x02; // ENABLE INTERRUPT ON MATCH BETWEEN TIMER2 AND OCR2A

^

C:\Users\Zero\Documents\Arduino\PulseSensorAmped_Arduino_1dot4\Interrupt.ino: At global scope:

Interrupt:27: error: expected constructor, destructor, or type conversion before '(' token

ISR(TIMER2_COMPA_vect){ // triggered when Timer2 counts to 124

^

exit status 1 expected constructor, destructor, or type conversion before '(' token

Read more: http://pulsesensor.proboards.com/thread/474/error-trying-default-code-nodemcu#ixzz4Rbo3ndv4`

[dotjavafile]

Please any help?

[LeonFedotov]

Im also having this problem

[hagelric]

Please any help?

Same error here!

[biomurph]

This is an older repo. We are directing everyone to use our new PulseSensor Playground library https://github.com/WorldFamousElectronics/PulseSensorPlayground

Please follow this tutorial https://pulsesensor.com/pages/getting-advanced Not all hardwares will work with our code that uses interrupts. Please read the entire tutorial and try the example code PulseSensor_BPM_Alternative.ino

Also, note that the ESP8266 ADC can only accept up to 1V max. I'm not sure how the nodemcu works this, but be aware of that.