wireguard-vyatta-ubnt

wireguard-vyatta-ubnt copied to clipboard

Clients can access LAN but not internet

2

### Package version 1.0.20220627 ### Firmware version 4.4.56 ### Device UniFi Security Gateway - UGW3 ### Issue description Using the setup in the [wiki guide](https://github.com/WireGuard/wireguard-vyatta-ubnt/wiki/EdgeOS-and-Unifi-Gateway), clients can connect to the...

JSaterdalen

### Package version 1 ### Firmware version 1 ### Device UniFi Security Gateway Pro 4 - UGW4 ### Issue description In the wiki, after curling and installing, there is this...

hb0nes

Remote endpoint setting gets lost at or after reboot

4

### Package version 1.0.20220627-1 ### Firmware version v2.0.9-hotfix.4 ### Device EdgeRouter X (SFP) - e50 ### Issue description Hi, previously I used 1.0.20211208-1 which worked fine for me. Then I...

vchrizz

Connecting to wireguard on edgerouter messes up outgoing UDP packets

21

Please reopen Lochnair/vyatta-wireguard#98 on this repo. The issues still exists and is reproducible by my three ERX routers. Edit: adding info from old issue If you use a Mediatek device...

virusmoere

I am requesting a Wiki guide for configuring a USG as a wireguard client only. I see a number focusing on USG as server but I just want to set...

robertgpeterson

wg-quick up fails on UXG-PRO : unable to initialize table 'raw'

3

### Package version 1.0.20211208 ### Firmware version 1.12.19 ### Device UniFi UXG-PRO ### Issue description I cannot start wireguard with following command : `wg-quick up /etc/wireguard/wg0.conf` My wg0.conf file is...

sirLeone

FAQ on site-to-site VPN using ipv6

1

The documentation for setting up client/server VPN on ipv4 is very good. However, I began to get into trouble when I tried to setup a UXG -> UXG site-to-site over...

matellis

Endpoint IP randomly changes to incorrect IP

4

### Package version 1.0.20211208 ### Firmware version 1.10.10 ### Device EdgeRouter 4 / 6P / 12 - e300 ### Issue description The Primary router has two public IP's : .29...

MichelGreijmans

Second Wireguard Tunnel uses wrong endpoint

1

Hello, **Package version** 1.0.20211208 **Firmware version** 2.0.9 Hotfix 2 **Device** EdgeRouter 4 / 6P / 12 - e300 **Description** I am not sure if my problem is a Wireguard problem...

pr0j3ctx

Any realiable method to shut down a tunnel and bringing it back?

1

Hi, I noticed that when I disable the wg interface to test a kill switch configuration, bringing it back does not route traffic through it because in the default route...

mleone87