Headphone jack not recognized after running script on Teemo (Debian 12)

[knightofcookies]

Describe the bug I followed the instructions in the README and rebooted after installation was a success. There was no change and I'm still on Dummy Audio.

Installation output:

WARNING: You may run into audio issues, even after running this script. Please report any issues on github.
Installing AVS
Installing topology
Installing modprobe config
Installing AVS firmware
Installing UCM configuration
Cloning into '/tmp/alsa-ucm-conf-cros'...
remote: Enumerating objects: 6517, done.
remote: Counting objects: 100% (2437/2437), done.
remote: Compressing objects: 100% (403/403), done.
remote: Total 6517 (delta 2141), reused 2055 (delta 2030), pack-reused 4080 (from 3)
Receiving objects: 100% (6517/6517), 832.03 KiB | 2.18 MiB/s, done.
Resolving deltas: 100% (4099/4099), done.
Audio installed successfully! Reboot to finish setup.
If this script has been helpful for you and you would like to support the work I do, consider donating to https://paypal.me/weirdtreething

pavucontrol:

Boardname Teemo

Logs debug-logs-Teemo-2025-02-08_17h57m.tar.gz

[WeirdTreeThing]

Headphone jack works on my teemo on fedora. I think debian 12 is too old for this.

[Tech-unsavvy]

I'm using Fedora and after running the script, the output device still showed Dummy Output. Then I read somewhere that AFTER you plug something into the jack, then the sound device shows up.