WeaselWasher

Ugh. Me too. I also had the XL USB drive disconnected issue. Wonder if it's related. Read this post here about noise: https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/3983#issuecomment-2349212153 I'm not sure how the Mk4 cables...

@CZDanol By different iterations, I mean that it was the same model, repeated. The black print was done in 6.1.2 and the red was done 6.2.

> So, you had a USB disconnected issue on 6.2.0? I had no fault, but I did have the missing perimeter (this is a thread for missing perimeters) is this...

@CZDanol Yes. It appears I am still getting the missing perimeters in today's print with 6.2  It's a little hard to see - as it's translucent. But you can...