Suggestion: Overscan adjustment

[Fancy2209]

The initial setup phase displayed fine But after picking the flipper for NT4 Driver I started having issues thanks to overscan, unfortunately can't enable just scan to make it go away Was immediately noticeable when I couldn't read the help text in the eula

As you see in the images, the task bar is cut

For this reason, I am asking if it'd be possible to add any kind of overscan adjustment

[Wack0]

probably not possible, NT expects 640x480 resolution as minimum, at least under text setup, so some part of the screen is always going to be cut off there.

for PAL there's a workaround of using 50fps 640x528 which is rendered letterboxed to the centre, and entire 640x480 is visible here

I could make a loader build to force that mode everywhere so the option to use it is available, at least for Wiis

not sure about gamecubes though.