"ISO: could not read sector 1b5a8"

[GalaxiumNation]

After doing Run firmware setup and Repartition disk or disk image for NT installation the raw disk image does not show up, only "Cancel"

I also tried Create disk images on SD/IDR for NT installation (SLOW) and Front SD Slot shows up but it doesn't matter what partition size I try it just returns error Failed to create image 1: Fault occured

I made sure to put the disk image in /nt/ and name it "disk00.img" I used qemu-img create disk00.img 2G to make it too.

[GalaxiumNation]

I've also tried:

• Formating disk00.img to fat32 to see if it would show up
• Making a 2nd one called disk01.img

But still nothing.

[Wack0]

What SD card are you using? Can you try a different one?

[GalaxiumNation]

Yeah, It was the sd card. I used a different one and it worked.

But now after repartitioning for NT, rebooting and running setup from cd00, I get: ISO: could not read sector 1b5a8 Error: Device error Press any key to continue...

And after pressing a key it just takes me back to the first screen

[horsiezoo]

What file system are you using for WinNT , FAT32 or NTFS? I found FAT32 format during Win install works best, ntfs is slow and had a few errors during win install. Also what is the exact name of the NT iso you are using? Eg nt 4.0 workstation for ….

[Wack0]

Yeah, It was the sd card. I used a different one and it worked.

But now after repartitioning for NT, rebooting and running setup from cd00, I get: ISO: could not read sector 1b5a8 Error: Device error Press any key to continue...

And after pressing a key it just takes me back to the first screen

this seems again like an SD card issue...

[GalaxiumNation]

:sob:

[GalaxiumNation]

Ok I tried a different sd card and it said the same thing

[Wack0]

In that case, maybe try a different ISO.