Voron-Trident
Voron-Trident copied to clipboard
VoronDesign
Voron Trident CoreXY 3D Printer design
Page 17 "Alternatively you can print the spacer that is included in the released files" - No mention of how to use this spacer - I take it you have...
https://github.com/VoronDesign/Voron-Trident/blob/VTr1/STLs/Gantry/chain_wire_anchor_a_3hole.stl chain_wire_anchor_a_3hole.stl => chain_wire_anchor_a_2hole.stl
The readme states that you can find the "build of materials", but I believe this should read as "bill of materials". "Web site" is most often spelled as one word...
What is: move one millimeter in a positive direction? What is positive? Maybe when you know how the coordinate system is about, but how would you know? Why not say:...
Created a BTT Kraken Config for Voron 2.4 so I eddited the config to match that of the trident. FYI I've also got a PR for the Kraken config in...
For ****** like me, it might be useful to mention, that you have to turn them clockwise. i.e.: "Rotate the zip tie loops CLOCKWISE by 90° ..." I was not...
there is that little 3d-print 'strain relief', what you can include there in order to put a zip-tie onto it, right? (like on page 230). If yes, this is not...
Since at the end I had some pieces left and then it's hard, without help, to figure out where they may are missing, or if there were just 2 variants...
Hi, The active cooler for Raspberry Pi 5 comes with plastic push-pins that sticks quite a bit on the back, and the location for them are exactly next to the...
The section on the X Axis Assembly says "Missing some bolts? The other two bolts will be installed later". Not only is this vague, but it is _much later_, like...
