Voron-Trident
Voron-Trident copied to clipboard
VoronDesign
Voron Trident CoreXY 3D Printer design
Added G90 to PRINT_START macro to prevent errors, when printer is in relative mode.
Specification and installation of the 2 M3 hex nuts on the carriage halves, corresponding to the M3x40 and M3x30 S.H.C.S.'s are missing. I would assume that, for ease of installation,...
 Fork crimp terminals are not included
seems like page 147 is pointing G as F and F as G extrusion
It would be helpful to call out the process for magnet installation for the hall effect sensor on pages 50 and 109. Page 50 states "HALL EFFECT ENDSTOP? If you...
Made a stock trident config using the spider 1.1 board.
Recommended Filtered Power Inlet TE 10EGG1-2 requires two fuses, while the BOM only lists one. Additionally, NA code prohibits fusing of neutral.
In the assembly manual and the upgrade manual there is no mention to the drill size for the access holes that need to be drilled in the extrusion.
I have found it hard to cross reference the right lengths to convert a 1.8 frame to a Trident frame for a 300mm printer. I also suggest that the Trident...
Page 216: "Power Inlet" title is not aligned correctly, so it is off the page. Page 217: Roll-in M3 nuts are missing from the diagram for the power inlet printed...
