Voron-Tap
Voron-Tap copied to clipboard
VoronDesign
Trying to debug some ressonance issues on my printer I was checking the overal boolts torques and accidentaly break this piece. But looking at it, I felt that this part...
Yes, a very very minor thing. I think in the manual, on page 25, it's stated that the toolhead holder screw needs a 2.5mm clearance. But considering that the mount...
Currently the TAP_Upper_PCB_r2 part has a 1mm deep relief for the pins and solder joints of the JST connector on the OptoTap v2.1 PCB so the PCB can sit flush...
On page 5, The github link for the STLs is incorrect, it points to https://github.com/VoronDesign/Voron-Tap/STLs instead of https://github.com/VoronDesign/Voron-Tap/tree/main/STLs 
On Page 29, the manual shows putting (4) M3x6 BHCS into the holes that mount to the X-Rail carriage. Right after that, it notes about installing the X end stop...
In the FAQ, it is mentioned that the hartk PCB must be changed to be compatible, this is not true for the v2.x OptoTap PCB, which does support 24v. It...
Upon reviewing the CAD, it appears that the holes for the CW2 Mounting on Tap Upper Wired part are off centre, causing them to be out of alignment with the...
On pg 28 for the current manual, it says "We could say that there is only one way they fit, but we don’t want to underestimate you." That's nice... but...
I'm on page 25 of the manual, attaching `Tap_Upper_PCB_r8.stl` and `Tap_Front_r8.stl`. I think the pockets for the M3x20 SHCS heads are slightly undersized. The screws got super hard to screw...
