Voron-Tap
Voron-Tap copied to clipboard
VoronDesign
I ordered OptoTap with the provided files (under OptoTap/Tap_Photosensor_PCB_v2/jlcpcb). The D1 LED are all placed upside down. I contacted jlcpcb and they replied: "Thanks for reaching out and sorry if...
On page 25 of the manual, the `upper` is attached to the `front` with two M3x20 diagonal screws. In addition, the two M3x16 mating screws also hold the parts. Later,...
Please make ears little bit stronger, i breke it third time :( Easy to edit, at least in F360 
After about 50 hours of printing I noticed the entire print head was coming loose. After disassembly I found the three M3 SHCS attaching the linear rail to the center...
Some optical sensors EE-SX398 do not correctly trigger due to the SIG pin voltage only flipping between 1.4V and 0V. This appears to be dependent on Sensor and the floating...
I'm on my 2nd printing of the "Tap Center" and have ran into the same issue twice. I use a hall effect endstop and thus use the magnet on the...
EDIT 2: 20230503: R8 should solve this. If you're experiencing this, please print and install the R8 revision of TAP, which includes actual clamps for the belts, which should completely...
I would like to see the team continuing to support MGN9H rails (at least a single rail) instead of only MGN12H. There is still a fairly large group of Voron...
RTV doesn't adhere well to the ABS and doesn't adhere at all to the magnets. The reference should be removed from the manual.
