Voron-Tap
Voron-Tap copied to clipboard
VoronDesign
also added a changelog to help summarize stl changes
I was looking at the CAD for the Tap an noticed interference between the MGN12 carriage and the tap_center component. I printed the STL in the repo, mounted the carriage...
The on Page 27 of the Manual mentioned `Fun Fact Voids™` didn't appear with my settings of **SuperSlicer** and since I couldn't figure out what settings was responsible for them...
The Magnet holder screw position on the left side(front view), when you tighten it it will pull back the magnet holder and away from the set position(inward), making it a...
Just a documentation tweak, since it's taken me an epically long time to gather this knowledge, might as well make it available out of the box! - Added diagnosis section...
In the **Operation at 5V** section of the OptoTap readme > The V2.4 OptoTap PCB has been tested to work fine from 5V to 24V inputs with no modifications. However,...
Hey thx for the great upgrade to version R8. Love the new Beld Clamp. Had some problems with loosen Belt and then i saw your update, well done. But one...
The manual is still using r1 stl filenames, see this image  * All of them have the wrong suffix (r1 vs r8) * `Tap_Magent_(Left|Right)_r1.stl` are now called `Tap_Center_(left|right)_r8.stl` *...
Manual specifies M3 6mm. 8mm and 12mm With part which have old version of [a]_Tap_Center_r8.stl. 8mm and 12mm bolts are too short for current version. In step file bolt lengths...
During the operation of coolers, vibration occurs, which is transmitted to the part in the form of a strong wobble
