SW/SKR Mini E3 v3 support

Open jharmn opened this issue 2 years ago • 3 comments

Pins remapped from v2->v3 Pin mappings tested on my SW

Apr 13 '22 15:04 jharmn

Can confirm that the new heater sensor pin is PC4 from my switchwire, so happy to see this config being submitted.

Apr 14 '22 04:04 jotpowers

This config is bad!!!!!!! There are few wrong pins !!!

starting with:

FAN2 Connector

############### [heater_fan extruder_fan] pin: PC15

should be PB15, PC15 is on E0_stop....

Apr 26 '22 16:04 luki343

@luki343 you said "a few wrong pins", but only specified the PC15->PB15 (which has been corrected. Did you find any other incorrect mappings?

May 01 '22 22:05 jharmn