Added Trident MKS Monster 8 V1.0 wiring diagram, This PR will not work properly without PR #260

[GadgetAngel]

*Added Trident MKS Monster 8 V1.0 wiring diagram, This PR will not work properly without PR #260 . It contains a link to the information in PR #260

*updated Electrical Index.md file to add the Trident MKS Monster 8 V1.0 (tri_monster8_uart_wiring.md)

*reused two additional files: a. monster8_RaspberryPi.md b. monster8_Resources.md

*added initial Removal of Jumpers diagram *added initial preparation - Set Jumpers diagram for MKS Monster 8 V1.0 *added description for Trident wiring diagram in MKS Monster 8 V1.0 *added wiring diagram for Trident - MKS Monster 8 V1.0 *added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for:

1. MCU XYZE with heat sinks

*added SSR wiring diagram *added URL to the Klipper Configuration by RealDeuce (https://raw.githubusercontent.com/VoronDesign/VoronUsers/master/firmware_configurations/klipper/RealDeuce/MKS-Makerbase/Monster8_v1.0_003/Voron2_Monster8_Config.cfg) for MKS Monster 8 V1.0 *Updated Color Pin diagram for MKS Monster 8 V1.0 *added original MKS Monster 8 V1.0 pinout *added URL to the original MKS Monster 8 V1.0 Github Repo