Voron-Documentation
Voron-Documentation copied to clipboard
Sources of the documentation website for all Voron 3D printers
Based on the work of GadgetAngel, but revised for mantainability. Also draws on https://derekkedziora.com/blog/dark-mode-revisited This may still need some tweaking. Primarily, I'm not happy with the current location of the...
I was reconfiguring my Legacy and noticed the guide references https://www.klipper3d.org/Config_Reference.html#bed_tilt instead of https://www.klipper3d.org/Config_Reference.html#z_tilt. As far as I can tell from both the V1 and the Legacy firmware configuration, the...
* correct title on SKR Pico pinout diagram * added URL to the Klipper Configuration from VoronDesign/Voron-0 GitHub Repo, Voron0.1 branch for SKR Pico board * add color pin diagram...
*updated Electrical Index.md file to add the Voron 0.1 SKR mini E3 V1.2. *added initial preparation diagram *added description for wiring diagram *added wiring diagram for Voron 0.1 *added the...
Bed Locating in Trident had the axis inverted. It instructed users that the Z endstop be located near max X rather than max Y. It also instructed the user to...
*Added Trident BTT Octopus Pro wiring diagram, This PR will not work properly without PR #252 . It contains a link to the information in PR #252 *updated Electrical Index.md...
*Added Voron 2.4 BTT Octopus Pro wiring diagram, This PR will not work properly without PR #250 . It contains a link to the information in PR #250 *updated Electrical...
*Add Voron2 Fysetc Spider V2.2 in SPI mode, This PR will not work properly without PR #241 . It contains a link to the information in PR #241 * this...
Add Voron2 Fysetc Spider V1.1 in SPI mode, This PR will not work properly without PR #236 . It contains a link to the information in PR #236 In Community/Electronics/...
*Add Voron2 FYSETC Spider V2.2 wiring diagram, This PR will not work properly without PR #240 . It contains a link to the information in PR #240 * this PR...